- Mono subwoofer amplifier 350 watts RMS x 1 at 4 ohms 600 watts RMS x 1 at 2 ohms
- Class D amp technology
- Variable low-pass filter (32-320 Hz, 12 dB/octave)
- Variable bass boost (0-12 dB at 45 Hz)
- Phase switch (0, 180 degrees)
- Wired remote bass control module included More Info:
- Preamp and speaker-level inputs – bare wire to RCA adapters included for high-level input
- Wiring and hardware not included with amplifier – 8-gauge power and ground
- Leads recommended Fuse rating: 30A x 2 Dimensions: 8-11/16″W x 2-1/16″H x 7-1/8″D
- Mono amplifier Four 30A fuses (2 installed/2 spares)
- 2 Speaker to RCA adapters
- RBC Remote level control w/ attached 16.5′ cable (RJ-25 terminated)
- Four 2-1/8″ screws
- Two 3/8″ screws
- Logo badge w/ adhesive backing Owner’s manual (Eng/Span/Fren/Others)
JBL Club A600 – 600W Class D Mono Subwoofer Amplifier
Out of stock
Looking like it was carved out of a block of steel, JBL’s Club A600 mono subwoofer amplifier can blast out up to 600 watts RMS to your sub. The Class D design ensures the amp’s high output won’t put too much strain your vehicle’s electrical system. A wired remote lets you control the bass level from the front seat.
Speaker-level inputs and signal-sensing turn-on allow this amplifier to simply integrate into almost any system, even one using the factory radio. You can use the low-pass filter and variable bass boost to maximize the performance of your subwoofer and enclosure, while a phase switch ensures that the bass will blend well with your full-range speakers.
